Artesian Spas Antigua Bedienungshandbuch PDF herunterladen (Seite 24)

7) Have the spa deck installed by a knowledgeable contractor to en

sure proper support.

8). If the spa is placed on the ground, even for a short period of time,

it must be supported by stones that are at least 2 inches thick and

12 inches square. A solid foundation is recommended as soon as

possible.

INSPECTION

You will want to inspect your spa, prior to ﬁlling it up with water.

Look for and remove any debris in the spa tub or in the ﬁlter area.

Verify that pump plugs are installed on the pumps and that the

pump unions are tight.

FILLING THE SPA WITH WATER

NOTE: DO NOT ﬁll your spa with hot water straight out of your

water heater or tap. This water may be as hot as 180 degrees F

and will cause damage to the surface and plumbing of the spa.

This will void your warranty. Level the spa before ﬁlling.

1) Prepare to ﬁll the tub by removing all debris.

2) Remove the ﬁlters from your spa (see Removing, Installing and

Cleaning Filters, page 33)

3) Place your garden hose in the circulation pump line.

SPA START-UP

Please read each step of the start up section prior to doing the

step.

SELECTING A LOCATION

In preparation for installing your new Artesian spa, you should

ensure that your chosen location meets these minimum guidelines:

1) Place your spa on a surface that is large enough for the entire spa to

ﬁt. Consider the space needed to easily access equipment

compartments and circuit breakers. Remember, all electronics

must be kept dry.

2) The spa must be on a solid, level foundation. Recommended: 4-

inch cement slab that has cured for at least 72 hours. Your warranty

will be voided if the spa is not properly installed. Structural damage

due to an improper foundation is not covered under warranty.

3) To avoid potential water damage to the skirt and frame, your spa

should be placed on a site where it will not be in the way of water

sprinklers.

4) OUTDOOR SPAS: Consider building codes, electrical and

plumbing codes, desired proximity to house, wind and sun exposure,

location of trees (falling leaves, shade), dressing area, landscaping

and lighting when selecting a location.

5) INDOOR SPAS: Floor surface must have traction to prevent slipping

when wet. A ﬂoor drain is optimum. As room humidity will increase

because of the spa, provide ample ventilation to prevent dry rot,

mildew and mold. Use materials that will withstand humidity. There

may be a need for cross-ventilation fans and/or dehumidiﬁers. The

spa chemicals may corrode some household metals. Provide ample

room if servicing should be needed. Strong foundational support is

vital, particularly if a second-story site is selected.

6) Ensure the equipment compartment is in a location where it will not

be damaged by water drainage. Cover the equipment compartment

with a heavy screen if rodents are a problem. Damage due to

rodents is not under warranty.

43 44

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare

Artesian Spas Antigua Bedienungshandbuch Seite 24

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Oberirdisches Schwimmbadzubehör Artesian Spas Antigua