Artesian Spas Antigua Bedienungshandbuch Seite 29

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 44
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 28
5453
KEYS AND FUNCTION cont...
FILTER CYCLE cont...
prevents excessive water temperatures due to a long filtration during
warm temperatures. The filter logo will blink for the remainder of the
filter cycle. If the water temperature cools to 1 degree F above the set
point before the end of the cycle, the filter cycle will resume for the
remainder of the time.
Manual Protection - If during a filter cycle, Pump 1, Pump 2, Blower/
Pump 3 or Light Key are pressed, the filter cycle is suspended and will
resume 40 minutes after the last pump has turned OFF. In systems
with a circulation pump, the circulation pump will continue to run, but
the ozonation will be suspended.
OZONE OUTPUT
The ozone output is active during the filter cycle, adjustable from 0 to
12 hours. If set without the Circ. Pump the ozone follows Pump 1 low
speed. If set with the Circ. Pump, the ozone follows the Circulation
Pump. The ozonator does not work during the filter cycle if there is a
filter cycle overtemp or if it is in manual protection.
CIRCULATION PUMP
The Circulation Pump is adjustable from 0-12 hours twice a day (with
filter cycle). It will turn OFF when the temperature of the water is 2
degrees above the set point or when the temperature of the water is 98
degrees F or above.
SMART WINTER MODE
When the spa is in Winter Mode, the pumps turn on when the
ambient temperature falls below 68 degrees F (20 degrees C). The
pumps activate for 1 minute every two hours or less, for at least 24
hours.
POWER-UP DETECTION
After a power-up, the display will blink until a key on the control panel
is pressed. This feature is to let the user know that a power failure has
occurred.
TEMPERATURE SENSOR FAILURE
After a power-up, the display will blink until a key on the control panel
is pressed. This feature is to let the user know that a power failure has
occurred.
Seitenansicht 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare